Serving the Riverside area  ·  (951) 783-4287  ·  Open Mon-Sun 7am-7pm
📞 (951) 783-4287 Free Quote

Metal Roofing in Loma Linda, CA (92354) · Local Professionals

Riverside Metal Roofing · Fast response in Loma Linda and the Riverside area · Free estimate 24h

✅ Licensed Contractor 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+311Verified Reviews
10Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured

Loma Linda is a city of hills and history, where mid-century stucco homes sit on sloped lots just below the medical campus and the flat streets near the 10 freeway. The mix of 1950s-70s ranch houses and newer two-story builds means roofs here face intense UV, dry Santa Ana winds, and the occasional heavy winter rain. We know the neighborhoods from the hillside streets near Bryn Mawr to the quiet cul-de-sacs off Barton Road.

Homeowners in Loma Linda (92354) call Riverside Metal Roofing because we understand the local wear patterns: sun-baked shingles that crack, flashing that fails after a decade of heat, and the need for roofing that can handle both the summer sun and the wind. We are based in Riverside and serve Loma Linda and the surrounding areas, and we are fully insured for your peace of mind.

Metal Roofing in Loma Linda (92354)

Loma Linda's terrain varies from flat lots near the 10 freeway to hillside properties with steep driveways and tight access. Many homes were built between the 1950s and 1970s, with low-pitched roofs that were originally shingle or concrete tile. Over time, the intense inland sun bakes these materials, causing them to become brittle and lose their seal. In the hills, proper drainage is critical to prevent water from pooling against foundations, and the dry Santa Ana winds can lift loose shingles or panels. We also see a lot of older stucco homes where the roof-to-wall flashing has deteriorated, leading to leaks during winter storms.

Our team has worked on roofs throughout Loma Linda and the Riverside area, from the streets near Loma Linda University to the residential neighborhoods off Mountain View Avenue. We know the local building department requirements and can help navigate permits for a full replacement. Whether you need a new metal roof installation or a repair on an existing one, we bring experience with the specific challenges of this city.

Our services in Loma Linda

How a Job Works in Loma Linda

Step 1: It starts with a call to (951) 783-4287 or a request through our website. We schedule a free on-site assessment at your Loma Linda property, where we inspect your current roof, check for damage, and discuss your options. We'll provide a written estimate and answer any questions about materials, timelines, and permits.

Step 2: Once you approve, we handle the work. For many Loma Linda homes, that means coordinating with the city for permits and possibly with an HOA if you live in a planned community. Our crews are experienced with tight lot access and steep grades, so we can navigate hillside properties safely. We'll keep you informed throughout the process and minimize disruption to your daily routine.

Step 3: After the job is done, we do a thorough cleanup, including magnet sweeping for nails and debris removal. We walk the property with you to ensure you're satisfied with the work. We leave your home clean and your new roof ready to protect you for decades.

Pricing for metal roofing in Loma Linda depends on the size and complexity of your roof, the material you choose, and the condition of the existing structure. As a ballpark, metal roof installation starts at $8 per square foot, standing seam at $10 per square foot, and metal roof replacement at $9 per square foot. For repairs, we start at $450 for leak fixes, and screw replacement starts at $750. We also offer metal roof over shingles (retrofit) starting at $7 per square foot, which can be a cost-effective option for some homes. The best way to get an accurate price is to call us at (951) 783-4287 for a free estimate. We'll assess your specific situation and provide a clear, no-obligation quote.

My house is on a hillside street near Hulda Crooks Park, and the roof takes a beating from wind and sun. What metal roofing options work best for that exposure?
For hillside homes with high wind exposure, we often recommend standing seam metal roofing because of its concealed fasteners and interlocking panels that resist wind uplift. Stone-coated steel is also a good choice as it mimics the look of tile or shingle while providing durability. We'll evaluate your roof's pitch and orientation to recommend the best system for your specific conditions.
A storm just blew through Loma Linda and lifted some shingles on my roof. Can you handle emergency repairs?
Yes, we offer storm and wind damage repair with free inspections. Call us at (951) 783-4287 to schedule an assessment. We'll secure the roof to prevent further damage and provide a detailed repair estimate. We prioritize active leaks and safety hazards.
What is the typical cost to replace a roof on a 1,500-square-foot ranch home in Loma Linda?
For a 1,500-square-foot home, a metal roof replacement might range from $13,500 to $18,000 depending on the material and complexity. That's based on $9 per square foot for replacement, but factors like roof pitch, number of penetrations, and accessibility can affect the final price. Call us for a free estimate tailored to your home.
Do I need a permit from the City of Loma Linda to replace my roof?
Yes, a roofing permit is typically required for a full replacement or re-roof in Loma Linda. The exact requirements and fees vary, so we recommend checking with the city's building department. We can help guide you through the permit process as part of our service.
My neighbor and I share a property line, and I'm planning a metal roof that might affect drainage. How do I handle this?
It's important to ensure your new roof doesn't direct water onto your neighbor's property. We can review your drainage plan and suggest solutions like gutters and downspouts that respect property lines. If you're in an HOA, we can also help coordinate approval for the roof style and color.
Are you fully insured for roofing work in Loma Linda?
Yes, we are fully insured with general liability and workers' compensation coverage. This protects you and your property in case of any accidents during the project.
How often should I have my metal roof inspected in Loma Linda's climate?
We recommend an inspection every two to three years, especially after major wind or rain events. The intense UV and Santa Ana winds can loosen fasteners and degrade sealants over time. Regular inspections can catch small issues before they become leaks. We offer free estimates for inspections.
Why choose us?

Trusted professionals in Riverside

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in Riverside

All your work handled by qualified professionals in Riverside

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

311+ Verified Client Reviews in Riverside

⭐⭐⭐⭐⭐ 4.9/5 · 311 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in Riverside · Response within 24h · No commitment · ☎ (951) 783-4287

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in Riverside ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm